V-Dipole antenna bracket 3D

V-Dipole antenna bracket 3DV-Dipole antenna bracket 3D

This is a little piece that can be used to make a V-Dipole Antenna.

It makes the antenna more ridged and guarantees a 120° angle between the elements.

The holes for the elements are 2mm in diameter.

UPDATE:

added a 4cm pole top mount and a version of the bracket with 3mm and 4mm holes.

Post-Printing

Assembly

  1. Slide in the two rods into the bracket
  2. Remove the plastic from a chock block an use the inserts to connect the cable
  3. add hotglue to sturdy up the connection


https://www.thingiverse.com/Tysonpower

It's only fair to share...Tweet about this on Twitter
Twitter
Share on Facebook
Facebook
Share on Reddit
Reddit
Share on LinkedIn
Linkedin
error: