IC-FR6300

| marzo 6, 2020

UHF DIGITAL REPEATER
Model No.: IC-FR6300/ UR-FR6300

Applicant:

ICOM Incorporated

1-1-32, Kamiminami, Hirano-ku
Osaka, Japan, 547-0003

Tested in Accordance With

Federal Communications Commission (FCC)

47 CFR, Parts 2, 22, 74, 80 and 90 (Subpart I)
And Industry Canada, RSS-119, Issue 12
Land Mobile and Fixed Transmitters and Receivers
Operating in the Frequency Range 27.41-960 MHz

IC-FR6300 UHF Digital Repeater

EQUIPMENT UNDER TEST (EUT) INFORMATION

The applicant has supplied the following information (with the exception of the Date of Receipt).

Brand Name: ICOM Incorporated
Product Name: UHF DIGITAL REPEATER
Model Name or Number: IC-FR6300
Serial Number: 11000208
Type of Equipment: Licensed Non-Broadcast Station Transmitter
Power Supply Requirement: 13.6 VDC nominal
Transmitting/Receiving Antenna Type: Non-integral
Primary User Functions of EUT: 2-Way Wireless Voice & Data repeater

EUT TECHNICAL SPECIFICATIONS

TRANSMITTER
Equipment Type: Mobile
Intended Operating Environment: Restricted to Occupational Use only
Power Supply Requirement: 13.6 VDC Nominal
RF Output Power Rating: 50 Watt (High) / 5 Watt (Low)
Operating Frequency Range: 400-470 MHz
RF Output Impedance: 50 Ohm.
Channel Spacing: 25 kHz, 12.5 kHz,15 kHz, 6.25 kHz
Occupied Bandwidth (99%): 16.60 kHz (25 kHz Analog)
10.45 kHz (12.5 kHz Analog),
3.80 kHz (6.25 kHz Digital)
Emission Designation*: 16K0F3E**, 11K0F3E, 4K00F1E, 4K00F1D
Antenna Connector Type: N

* For an average case of commercial telephony, the Necessary Bandwidth is calculated as follows:

For FM Voice Modulation:

Channel Spacing = 25 KHz, D = 5 KHz max, K = 1, M = 3 KHz
Bn = 2M + 2DK = 2(3) + 2(5)(1) = 16 KHz
Emission designation: 16K0F3E


Channel Spacing = 12.5 KHz, D = 2.5 KHz max, K = 1, M = 3 KHz
Bn = 2M + 2DK = 2(3) + 2(2.5)(1) = 11 KHz
Emission designation: 11K0F3E

**Note: The emission designation 16K0F3E with 25 KHz Channel bandwidth is only applied to the device operated in FCC Rules Part 22, 74 & 80 frequencies. The operation of 16K0F3E emission will be disabled in the firmware by the manufacturer for device that operates in FCC Rules Part 90 frequencies (Private Land Mobile) as declared by the applicant.

 

LIST OF EUTS PORTS

Port

Number

EUT’s Port Description Number of Identical Ports Cable Type/Termination
1 Tx Antenna Connector 1 Terminated to 500 Load
2 Microphone Jack 1 Non-shielded
3 DC Power Receptacle 1 Non-shielded
4 Rx Antenna Connector 1 Terminated to 500 Load
5 DC Fan Input Power Receptacle 1 Non-shielded
6 DB25 1 Shielded
7 Bus1/2 RJ45 2 Non-shielded
8 LAN 1 Non-shielded
9 Ext Speaker Jack 1 Non-shielded
10 GPS Antenna 1 GPS Antenna

ANCILLARY EQUIPMENT

The EUT was tested while connected to the following representative configuration of ancillary equipment
necessary to exercise the ports during tests:

Ancillary Equipment # 1
Description: Microphone
Brand name: ICOM
Model Name or Number: HM-152
Connected to EUT’s Port: Microphone Port
Ancillary Equipment # 2
Description: External Speaker
Brand name: ICOM
Model Name or Number: SP-35
Connected to EUT’s Port: Ext. Speaker

 

OPERATIONAL TEST CONDITIONS & ARRANGEMENT FOR TEST SIGNALS

Operating Modes: The transmitter was operated in a continuous transmission mode with the carrier modulated as specified in the Test Data.
Special Test Software: N/A
Special Hardware Used: N/A
Transmitter Test Antenna: The EUT is tested with the antenna port terminated to a 50 Ohm RF Load.

 

Transmitter Test Signals
Frequency Band: 400-470 MHz

Test Frequencies:

(Near lowest, near middle & near highest frequencies in the frequency range of operation.)

406.2 MHz, 450.1 MHz, 469.975 MHz
Transmitter Wanted Output Test Signals:
Transmitter Power (measured maximum output power): 52.36 W High
Normal Test Modulation: FM Voice/Digital
Modulating signal source: External

About the Author:

Filed in: Hamradio

Comments are closed.

error: