AOR AR-DV10 FCC Certification

| mayo 8, 2018

AOR AR-DV10 FCC Certification

AOR U.S.A., INC.

Authority On Radio Communications 20655 S. Western Ave., Suite 112 Torrance, CA90501, U.S.A.

Tel: 310-787-8615 Fax: 310-787-8619

7 May 2018

Yaesu Musen Co., Ltd.

13F, Bldg 2-5-8 Higashi-Shinagawa-ku

Tokyo 140-0002

Japan

AOR AR-DV10 FCC CertificationSUBJECT:

Applications for Certification FCC ID: 1C: 22833-ARDV10 Model: AR-DV10 To Whom It May Concern:

We, the undersigned, hereby authorize Mr. Kouji Taguchi at Yaesu Musen Co., Ltd. on our behalf, to apply for certification on our equipment referenced above. Any and all acts carried out by Yaesu Musen Co., Ltd. on our behalf shall have the same effect as acts of our own.

This is to advise that we are in full compliance with the Anti- Drug Abuse Act. We, the applicant, are not subject to a denial of federal benefits pursuant to Section 5301 of the Anti-Drug Act of 1988, 21 USC853a, and no party to the application is subject to a denial of federal benefits pursuant to that section.

Regards,

Shigeru Takario, President


AOR AR-DV10 FCC CertificationGENERAL INFORMATION

EUT Description SCANNING RECEIVER
Model Number AR-DV10
Operating Range 100 kHz – 1300 MHz
Test Range 30 MHz – 960 MHz*
Receiver Circuit
Type
Superheterodyne
Lowest Internal > 9 kHz
Frequency
Antenna Connector Reverse SMA
Power Source Battery Operated Exclusively
Production
Test Item None
Timco Engineering, Inc.
849 NW State Road 45
Newberry, FL 32669
Designation #: US1070

 

*NOTE: 15.101(b) Receivers operating above 960 MHz or below 30 MHz, except for radar
detectors and CB receivers, are exempt from complying with the technical provisions of this
part but are subject to §15.5.

AOR AR-DV10 FCC Certification

REPORT SUMMARY

Regulatory Standard CFR Title 47 FCC Rule part 15B § 15.109, 15.111, &
15.121
Test Procedures FCC Part 15.31, 15.33, 15.35
ANSI C63.4 – 2014
Operational Modes Stopped at the Lowest, middles, and highest frequency
of each frequency range. In addition, scanning all
frequencies of tuning range.
Low: 30 MHz
Test Frequencies Middle: 100 MHz, 500 MHz
High: 960 MHz
Scan: 30 MHz to 960 MHz
Environmental
Condition in the
laboratory
Temperature: 24-26°C
Relative humidity: 50-65%
Barometric Pressure: 1021 mb
Deviation from the
standard/procedure
No deviation

 

RESULTS SUMMARY

Test Item FCC Rule Part Result
Radiated Spurious
Emissions
15.109 Pass
15.111 Receiver
Conducted Power
15.111(a) NA(1)
15.121 38 dB
Rejection
38 dB na(2)
Powerline Conducted 15.107 Pass
Emissions

 

RADIATED SPURIOUS EMISSIONS

Rule Part No.:  FCC Part 15 Subpart B1

Requirements: FCC Part 15.109(a) Radiated Emission Limit

 

Class B Field Strength Limits @ 3 Meters
Frequency Level
(MHz) (dBuV/m)
30 – 88 40.0
80 – 216 43.5
216 – 960 46.0
Above 960 54.0
Procedure: FCC Part 15.109(f) Radiated Emission Limit
For a receiver which employs terminals for the connection of an
external receiving antenna, the receiver shall be tested to demonstrate
compliance with the provisions of this section with an antenna
connected to the antenna terminals unless the antenna conducted
power is measured as specified in §15.111(a).FCC Part 15.33(b)(3) Freauency range of radiated measurementsFCC Part 15.35(a) Measurement detector functions and bandwidths

ANSI C63.4 Methods of Measurement of Radio-Noise Emissions from
Low-Voltage Electrical and Electronic Eauipment 9 kHz to 40 GHz

§ 6.2 Operating conditions
§ 6.3 Arrangement of EUT

§ 8.3.1 Exploratory radiated emissions measurements
§ 8.3.2 Final radiated emission measurements

Configuration: The scanner receiver spurious emissions are to be measured when the
receiver is in the scanning mode and repeated when the scanning is
stopped.

About the Author:

×

Comments are closed.

error: