Alinco DJ-MD5 FCC Certification
Alinco DJ-MD5 FCC Certification
DJ-MD5, DJ-MD5T, DJ-MD5TGP
VHF/UHF DUAL BAND DIGITAL TRANSCEIVER
Test Report Certification
| Applicant Name | Alinco Incorporated, Electronics Division |
| Applicant Address | Yodoyabashi Dai-Bldg 13F, 4-4-9 Koraibashi, Chuo-Ku, Osaka 541-0043, Japan |
| Manufacturer Name | Alinco Incorporated, Electronics Division |
| Manufacturer Address | Yodoyabashi Dai-Bldg 13F, 4-4-9 Koraibashi, Chuo-Ku, Osaka 541-0043, Japan |
| Product Designation | VHF/UHF DUAL BAND TRANSCEIVER |
| Brand Name | ALINCO |
| Model Name | DJ-MD5, DJ-MD5T, DJ-MD5TGP |
| Different Description | All the same, except for the model name. The test name is DJ-MD5. |
| EUT Voltage | DC7.4 V |
| Applicable Standard | IEEE Std. 1528:2013 FCC 47CFR § 2.1093 IEEE/ANSI C95.1:2005 |
SUMMARY OF MAXIMUM SAR VALUE
The maximum results of Specific Absorption Rate (SAR) found during testing for EUT are as follows:
Highest Report standalone SAR Summary (50% duty cycle)
| Frequency
Band |
Type of signal | Separation | Highest Reported 1g-SAR(W/Kg) | |
| Face Up (with 25mm separation) | Back Touch | |||
| 450 | Analog | 12.5KHz | 1.574 | 3.393 |
| Digital | 12.5KHz | 0.784 | 1.578 | |
| 150 | Analog | 12.5KHz | 0.170 | 0.901 |
| Digital | 12.5KHz | 0.082 | 0.371 | |
This device is compliance with Specific Absorption Rate (SAR) for Occupational / Controlled Exposure Environment limits (8.0W/Kg) specified in 47 CFR part 2 (2.1093) and ANSI/IEEE C95.1, and had been tested in accordance with measurement methods and procedures specified in IEEE 1528-2013 and the following specific FCC Test Procedures:
- KDB447498 D01 General RF Exposure Guidance v06
- KDB 865664 D01 SAR Measurement 100MHz to 6GHz v01r04
- KDB 643646 D01 SAR Test for PTT Radios v01 r03
GENERAL INFORMATION
| Product Name | VHF/UHF DUAL BAND TRANSCEIVER |
| Test Model | DJ-MD5 |
| Hardware Version | V1.00 |
| Software Version | V2.02 |
| Exposure Category: | Occupational/Controlled Exposure |
| Device Category | UHF & VHF Portable Transceiver |
| Modulation Type | FM &4FSK |
| TX Frequency Range | 400-480MHz/136-174MHz |
| Rated Power | 5W/2.5W/1W/0.2W (It was fixed by the manufacturer, any individual can’t arbitrarily change it) |
| Max. Average Power | UHF: 36.83dBm, VHF: 36.87dBm |
| Channel Spacing | 12.5 KHz |
| Antenna Type | Detachable |
| Antenna Gain | 2.15dBi |
| Body-Worn Accessories: | Belt Clip with headset |
| Face-Head Accessories: | None |
| Battery Type (s) Tested: | DC7.4V,1700mAh (by battery) |
Manufacturer Specifications
■ GENERAL
| Frequency Range | 136-174MHz / 400-480MHz |
| Number of Channels | 4000ch |
| Zones per Radio | 250 zone (MAX 250ch/zone) |
| Channel Spacing | Analog: 12.5kHz |
| Digital: 12.5kHz | |
| Operating Voltage | 7.4V DC nominal |
| Operating Temperature Range | -10°C to +40°C |
| Frequency Stability | ±2.5ppm |
| Antenna Impedance | 50 Ohm. |
| Dimensions (W x H x D Approx.) with EBP-88 Li-ion pack | 59x118x40 mm (2.32×4.65×1.57 inches) |
| Weight (Approx.) with EBP-88 Li-ion pack | 256g /9.03 ounces |
| Recording time | 14 hours |
■ TRANSMITTER
| RF Power Output | 5W / 2.5W / 1W / 0.2W |
| Spurious Emission | Less than 1GHz: -36dBm |
| More than 1GHz: -30dBm | |
| FM Hum & Noise (Analog) | 12.5kHz: 36dB |
| Modulation | Analog: 11K0F3E |
| Digital: 7K60FXD/7K60FXW |
■ RECEIVER
| Sensitivity (Analog/12dB SINAD) | 12.5kHz: 0.35uV |
| Sensitivity (Digital/BER) | 5%: 0.3uV |
| 1%: 0.7uV | |
| FM Hum & Noise (Analog) | 12.5kHz:40dB |
| Audio Distortion | Less than 5% |
| Audio Output | 1000mW /16 |
Names and Operations of Parts
Front
© Alinco Incorporated, Electronics Division