FTdx1200 MOD MARS/CAP

| mayo 26, 2014

FTdx1200 MOD MARS/CAP

Disconnect the radio from all power, accessories, and antennas prior to attempting this modification.

Use a grounded low power thermo control soldering iron

Turn the radio over and take off the back cover.Locate the control board (Right front corner) you will see 9 jumpers, marker 1 through 9.

FTDX1200 MOD MARS/CAP

FT-DX1200 MOD MARS/CAP

Add a Solder bridge to pad number 5.

FTDX1200 MOD MARS/CAP

Reassemble the radio.

Do a Full Reset by holding the “FAST” and “LOCK” buttons in while pushing the “POWER” switch to ON.

The TX range is now 1.8-30Mhz and 50-54Mhz.

Related Posts

  • FTdx3000 MOD MARS/CAPFTdx3000 MOD MARS/CAP The jumpers are called JP3001 until JP3009, in my radio I have the jumpers JP3006 and JP3007 closed, 0 ohms.I do the jumper JP3005 and reset the radio, now it is […]
  • FT-991 MARS ModFT-991 MARS Mod Yaesu FT-991 Frequency Expansion Information Confidential Model: FT-991 Original TX Freq. Range: 160-6m Amateur Bands Date: 15 December 2014 New TX Freq. […]
  • FT-891 MARS modificationFT-891 MARS modification This modification gives the FT-891 a continuous TX range of 1.8 - 56 MHz. Open the top of the radio up the spealer and near to dsp you ca see 2 slot, solder […]
  • FT-450 MARS ModFT-450 MARS Mod MARS Mod for FT-450 Important Notice This information is solely for use by licensed members of MARS (Military Affiliate Radio System) or CAP (Civil Air Patrol), and […]
  • FT2D Yaesu ModFT2D Yaesu Mod Yaesu FT-2D and FT-2DR Mars Cap Modification Remove battery pack and locate rubber gasket on back of the radio and remove. Then locate chip resistor marked […]
  • Yaesu FTM-100 MARS/CAP modYaesu FTM-100 MARS/CAP mod In order to expand the frequency coverage (RX and TX) you need to remove R1850 on the european model. R1850 is located near the paper covered “UPDATE” […]
It's only fair to share...Share on FacebookShare on Google+Tweet about this on TwitterShare on LinkedInShare on Reddit

About the Author:

Filed in: Hamradio
×

Comments are closed.

error: